MEDIFIT BATTERY ALCOHOL TESTER

Description
Alcohol tester.

Warnings
- The test detects the blood alcohol concentration at the time of measurement. Blood alcohol levels may vary depending on environmental conditions. This product should be used only as a prevention tool and to promote safer and more responsible driving. It provides a purely indicative measurement and does not exclude or replace any checks carried out by the competent authorities, which may result in values ​​different from those resulting from the test. The alcohol content values ​​measured by the test are not relevant for legislative purposes, nor do they exempt the subject from any liability. Improper storage and/or incorrect use of the product may affect the accuracy of the measurement.
- Do not rely solely on this product for any reason to determine whether you are intoxicated and therefore decide to drive a vehicle, use dangerous equipment, or engage in risky activities.
- INNOLIVING Spa is not responsible for the consequences resulting from improper use of this product.
- Before use, make sure the appliance is intact and free of visible damage. If in doubt, do not use the product and contact an authorized service center.
- After use, always store the product away from heat sources, sunlight, humidity, sharp objects or similar.
- Do not use alcoholic substances such as paints or insecticides near the tester.
- Do not use chemicals to clean the tester. Never immerse the product in water or other liquids, as this may damage the sensor.
- Do not attempt to repair the product yourself, as this will void the warranty. Always contact an authorized service center.
It takes about 20 minutes for alcohol to be absorbed into the bloodstream from the digestive system; therefore, it is recommended to take the measurement 20 minutes after consuming alcoholic beverages. If the measurement is taken immediately after drinking, the results may reflect the alcohol concentration in the beverage and not the actual concentration in the blood.
- To obtain more accurate measurement results, the interval between two consecutive measurements should be greater than 3 minutes.

Cod. MD-644